| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| Runout on a Drill Press Quill http://www-.luthiersforum.com/forum/viewtopic.php?f=10102&t=653 |
Page 1 of 1 |
| Author: | Brock Poling [ Sat Jan 08, 2005 6:19 am ] |
| Post subject: | |
Is there any way to fix the run out on a drill press quill. My Delta 350 works fine for bits, but when I chuck up a robo sander or anything like that I get too much wobble. Thoughts? |
|
| Author: | JJ Donohue [ Sat Jan 08, 2005 6:39 am ] |
| Post subject: | |
Brock...I have the same drill press. I purchased a drum sanding system from Lee Valley that uses a bearing disc into which the bottom of the drum is captured. http://www.leevalley.com/wood/page.asp?page=20202&category=1 ,42500&ccurrency=2&SID= It rotates without any runout whatsoever. You might use something similar with the Robo-Sander. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|